TM 11-7025-221-10
2-6. List of Message D i s p l a y s - Continued.
Message Displays - Continued
Description
Message displayed
Message is displayed when POWER ON/OFF
switch is set to ON. Message also displays the
current system mode of operation. (When TD-
1337(V)/G is turned on, it assumes same mode
it was in when power was turned off.)
Message is displayed when system
PRELIM COMPOSITE RATE IN KBS
MUX >
DEMUX1 =
mode change routine is performed and
DEMUX2=
DEMUX3=
STEP
TD-1337(V)/G is to be placed in preliminary
DEMUX4=
mode. At each entry point designated by
prompt, enter assigned SG rate (in kb/s).
Message is displayed for information when
composite rates display routine is performed.
NOTE
"DEMUX2" through "DEMUX4" portion
of message not displayed on V2 and
V4 models,
PRESENT ORDW MODE =
Message is displayed in answer orderwire
ORDW CALLS: NON-SECURE
call routine. The message presents:
SECURE
ANDVT
Present orderwire mode (secure or non-secure)
of local TD-1337(V)/G.
Type of orderwire call being received and which
demux is receiving call.
NOTES
"ANDVT" portion of message not
displayed in V1 and V2 models.
If incoming call is either secure or
non-secure and local TD-1337(V)/G
is operating in opposite orderwire
mode, call cannot be completed until
local orderwire mode is changed.
REMOTE
DATA MISSING
Message is displayed when a mode is selected
or a routine is performed that requires Rmux
(1 to 4) configuration data and data has not
been entered in associated memory area.
REMOTE NOT ON LINE
Message appears when a download to non-nodal
transmit routine is performed and remote TD-
1337(V)/G selected is determined to be off line.
(Remote TD-1337(V)/G is either turned off or
operating at an incompatible rate.)
2-20
