TM 11-7025-221-10
2-6. List of Message Displays - Continued.
Message Displays - Continued
Description
Message displayed
Last message displayed in a local mux con-
figuration routine. Messages indicates
that data for mux has been loaded into des-
ignated memory area. The SG composite rate
is also displayed.
Last message displayed in a Rmux minimum
configuration routine or a Rmux config-
uration for downloading routine. Message in-
dicates that data for a given Rmux has been
loaded into designated memory area. The SG
composite rate is also displayed.
I
# Enter number (1 or 2) of memory to be used
in routine. Message also displays
mode in which TD-1337(V)/G is operating.
NOTE
If TD-1337(V)/G is operating in memory
1 or memory 2 mode, you cannot se-
lect that memory for this step.
MEMORY 1 COMPOSITE RATE IN KBS
Message is displayed when composite rates
MUX >
DEMUX1 = DEMUX2=
display routine is performed. The composite
DEMUX3=
DEMUX4=
STEP
rates entered in memory 1 for local mux and
each configured demux are displayed.
NOTE
"DEMUX2" through "DEMUX4" portion
of message not displayed on V2 and
V4 models.
Message is displayed when composite rates
display routine is performed. The composite
rates entered in memory 2 for local mux and
each configured demux are displayed.
NOTE
"DEMUX2" through "DEMUX4" portion
of message not displayed on V2 and
V4 models.
# Enter "1" to accept (make) system mode
change. Both old mode (present mode) and
new mode (mode which you are changing to)
are displayed. Otherwise, enter "2" to abort sys-
tem mode change.
2-17
