TM 11-7025-221-10
Displays - Continued.
2-6. List of Message
Message Displays - Continued
Description
Message displayed
You have entered data that TD-1337(V)/G cannot
ILLEGAL ENTRY, REENTER
use. Press CLR key and reenter data for step
being performed. If message reappears, confirm
configuration data being entered is valid (legal).
Example:
Operator enters 577 for a port rate. This is not
an acceptable entry. Operator presses CLR key
and then enters 576 for requested port rate. Dis-
play advances to next action required.
1
Message is displayed when a mode is selected
LOCAL DATA MISSING
or a routine is performed that requires local mux
configuration data and the data has not been
entered into the associated memory area.
# Enter "0" if local mux is to be con-
LOCAL/REMOTE MUX SELECTION >
LOCAL MUX=0 RMUX 1=1 RMUX 2=2
figured or enter number (1 to 4) of Rmux to
R M U X 3=3 RMUX 4=4
be configured.
NOTE
"RMUX 2" through "RMUX 4" portion
of message not displayed on V2 and
V4 models.
Message is displayed when TD-1337(V)/G is op-
erating in a given memory mode (1 or 2) and
you attempt to perform a generate configuration
routine with that same memory area. A generate
configuration routine cannot be performed with
memory being used for operation.
The last part of each generate configuration rou-
tine or the receive control telemetry routine in-
volves loading of configuration data into memory.
This message is displayed if memory loading
is aborted.
Last message displayed in receive control tele-
MEMORY LOAD COMPLETE
metry configuration routine. Message indicates
that downloaded data has been. entered in des-
ignated memory area.
2-16
