TM 11-7025-221-10
2-6. List of Message Displays.
Each of the messages that can be displayed on a TD-1337(V)/G are listed and described in the below
chart. The messages are listed in alphabetical order.
NOTES
Symbol "#" precedes some of the message descriptions. This
symbol indicates that operator actions (make selections or enter
data) are determined by data supplied by the authority originating
the configuration requirement.
In the following messages that involve port entries or port se-
lections, the maximum number of ports that can be displayed are
shown. Based on the model (V1, V2, V3, or V4) being used,
and the routine being performed, less than the maximum number
of ports may actually be displayed.
Message Displays
Message displayed
Description
ALARM INHIBIT ACTIVATED
Message displayed when 5-minute audible
alarm inhibit is activated.
ALARM INHIBIT ACTIVATED
Message displayed when alarms recall routine
ALARMS RECALL TERMINATED
is selected and 5-minute audible alarm inhibit
is activated. Operator must wait until 5-minute
inhibit cycle is completed or perform 5-minute
audible alarm inhibit routine and clear inhibit
function to perform alarms recall routine.
ALARM INHIBIT CLEARED
Message displayed when operator clears
(cancels) 5-minute audible alarm inhibit.
ALARMS RECALL COMPLETE
Last message displayed when all diagnostic
information has been presented in alarms
recall routine.
CALL # NOT IN CONFIG
Call number entered for routine being per-
I
I
formed is not part of local TD-1337(V)/G
orderwire configuration.
CESE MAJOR NEW
STEP
One of message headings that appear when
alarms recall routine is performed. Heading can
be followed by lines of diagnostic information.
Refer to paragraph 2-21 for further description.
NOTE
Message is not applicable to and is not
displayed for V1 and V2 models.
2-12
