TM 11-7025-221-10
2-6. List of Message Displays - Continued.
Message Displays - Continued
Description
Message displayed
GROUP MODEM CABLE
COND
# Enter assigned number of reels of cable
# OF 1/4 MILE REELS=l THRU 8
(1 to 8 for data rates up to 576 kb/s or
NONE=O
1 to 4 for data rates of 1024 or 1152
or enter "O" if no reels are designated.
CONFIGURATION SELECTION
Enter number (1, 2, or 3) of configuration
GENERATE=2 TRANSMIT=3
routine to be performed.
Enter "O" when performing Rmux configura-
tion routines. Only enter "1" if
back option is to be used. Loopback option is
used in troubleshooting (Chapter
You have selected a demux that you had set
as inactive in a previous step. Press CLR key
and reenter data. If message is repeated, check
your configuration data.
Last message displayed when all messages in
DISPLAY FUNCTION COMPLETE
a selected display routine have been
displayed.
Enter "1" if you accept, or enter "2" if
you abort a download to non-nodal trans-
mission for memory 1 or memory 2. This down-
load transmission, if accepted, configures your
Message also dis-
local mux and one
plays present operating mode of local
1337(
NOTE
You cannot accept a download trans-
mission for a given memory if you are
operating in that memory mode. In this
case, place local TD-1337(V)/G in an-
other operating mode (system mode
change routine) and repeat receive
control telemetry routine.
DOWNLOAD TO NON-NODAL
# Enter call number of remote TD-1337(V)/G
ENTER NON-NODAL CALL NUMBER
to receive download to non-nodal trans-
mission.
END OF ORDERWIRE CONFIGURATION
Last message that is displayed when gen-
erate orderwire configuration routine is
completed.
2-14
