TM 11-7025-221-10
2-14. Answer Orderwire Call Routine (V3/V4 Models) - Continued.
Answer Orderwire Call Routine (V3/V4 Models) - Continued
Step
Operator action/message displayed
3
Press FUNC key and then press ORDERWIRE CHG key. Observe following message is displayed.
Repeat step 1 and then go to step 4.
4
Press CLR key to clear display.
Answer orderwire call:
5
Use Vinson if call is secure mode.
Use H-250 if call is non-secure mode.
Use ANDVT equipment if call is ANDVT.
2-15. Make Orderwire Call Routine.
Perform the following procedures to call another station in the network. These procedures can be performed
without affecting normal equipment operation.
NOTES
Orderwire configuration data (your local call number and call num-
ber of party being called) must have been entered in NVM (para
TD-1337(V)/G must be operating in preliminary, memory 1, or
memory 2 mode of operation to use orderwire routines.
When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
Start with step 1 and perform the action in the procedures as
directed. Messages that appear on the display are shown in bold
type.
Make Orderwire Call Routine
Step
Operator action/message displayed
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press
ORDERWIRE CALL key.
2-37
