TM 11-7025-221-10
2-13. Answer Orderwire Call Routine (V1/V2 Models) - Continued.
Answer Orderwire Call Routine (V1/V2 Models) - Continued
Operator action/message displayed
Step
4
Press CLR key to clear display.
Answer orderwire call:
5
Use Vinson if call is secure mode.
Use H-250 if call is non-secure mode.
2-14. Answer Orderwire Call Routine (V3/V4 M o d e l s ) .
Perform the following procedures to answer an orderwire call from another station in the network. These
procedures can be performed without affecting normal equipment operation.
NOTES
Audible ALARM horn sounds and "0" appears on upper right-hand
corner of display to indicate that an orderwire call is being received.
If audible ALARM horn sounds and a "T" appears on upper right-
hand corner of display, this indicates that a control telemetry trans-
mission has been received (refer to paragraph 2-37).
When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
Start with step 1 and perform the action in the procedures as
directed. Messages that appear on the display are shown in bold
type.
Answer Orderwire Call Routine (V3/V4 Models)
Step
Operator action/message displayed
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press
ORDERWIRE ANS key.
* > SECURE or NON-SECURE I
2
a Source of orderwire call.
0 =
Local
CNCE
Go to step 4 if ORDW CALLS is ANDVT or
PRESENT ORDW MODE (SECURE or NON-SECURE)
is the same as incoming ORDW CALLS mode.
Go to step 3 if modes are different.
2-36
