TM 11-7025-221-10
2-11. System Mode Change Routine - Continued.
System Mode Change Routine
Step
Operator action/message displayed
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press SYSTEM
MODE key.
2
SYSTEM IS IN * M O D E
MEMORY 1, MEMORY 2,
STEP IF SYSTEM MODE CHANGE IS
INACTIVE, PRELIM, or
DESIRED, OTHERWISE CLEAR
TD-976 is displayed.
Press STEP key.
3
Press key representing selected mode (1 through 5) and then press ENTRY key.
Go to step 4 if "4" key is pressed.
Go to step 5 if "1, 2, 3, or 5" is pressed.
4
If correct rates are entered at each entry point, press ENTR key to advance display to next
step. Otherwise, at each entry point indicated by prompt, press CLR key, enter assigned rate,
and then press ENTR key. If Demux is inactive, press CLR key, press "0" key, and then
press ENTR key.
5
Press `1" key and then press ENTER key. Observe following message is displayed to indicate
procedure is completed.
SYSTEM MODE CHANGE COMPLETE
2-33
