TM 11-7025-221-10
2-15. Make Orderwire Call Routine - Continued.
Make Orderwire Call Routine - Continued
Operator action/message displayed
Step
2
Check that you are in the correct orderwire mode (SECURE if using Vinson or NON-SECURE
if using H-250). In a V3 or V4 model, either mode can be used for ANDVT.
If mode is correct, enter call number (1 to 16) of station being called and then press ENTR
key. Go to step 4 if you are using a V3 or V4 model. Go to step 5 if you are using a
V1 or V2 model.
If mode is not correct, perform step 3 and then repeat steps 1 and 2.
Press FUNC key and then press ORDERWIRE CHG key. Observe following message is displayed:
3
4
If you are using a Vinson or H-250 handset, press "1" key and then press ENTR key
If you are using ANDVT equipment, press "2" key and then press ENTR key.
Check that RING BUSY message is displayed for approximately 2 seconds and then RING COM-
5
PLETED message is displayed. Wait for audible response from called party.
NOTE
To repeat orderwire call, all steps have to be performed.
After call is completed, press CLR key to clear display.
6
2-38
