TM 11-7025-221-10
2-27. Generate Local Mux Configuration Routine (VI/V2 Models) - Continued.
b. Procedures. Perform the following procedures to enter local mux configuration data in memory 1
or memory 2.
NOTES
When a local mux configuration routine is performed, all demux
configuration data in the NVM for the selected memory (1 or 2)
is erased. Each active demux will have to be configured after
this routine is completed.
This q symbol in a step indicates that operator will enter con-
figuration data supplied by authority that originated the config-
uration.
When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph,
Start with step 1 and perform the action in the procedures as
directed. Messages that appear on the display are shown in bold
type.
Local Mux Configuration Routine (V1/V2 Models)
Operator action/message display
Step
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press SYSTEM
CONF key.
>
2
CONFIGURATION SELECTION
DISPLAY=1 GENERATE=2 TRANSMIT=3
Press "2" key and then press ENTR key.
>
3
GENERATION MODE
NEW CONFIGURATION= 1 CONTINUE=2
=3
EDIT EXISTING CONFIGURATION
Press "1" key and then press ENTR key.
4
Press
key and then press ENTR key.
2-63
