TM 11-7025-221-10
2-25. Display Orderwire Configuration Routine.
Perform the following procedures to display orderwire configuration data in NVM. These procedures can
be performed without affecting normal equipment operation.
NOTES
When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
Start with step 1 and perform the action in the procedures as
directed. Messages that appear on the display are shown in bold
type.
Display Orderwire Configuration Routine
Step
Operator action/message display
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press
ORDERWIRE CONF key.
2
Press "1" key and then press ENTR key.
3
Press STEP key to advance to next display.
4
Press STEP key to advance to next display. Repeat this step to display orderwire assignments
for remote TD-1337(V)/G's and remote CNCE'S in network (max of 4) until following message
is displayed. At this time the routine is completed.
5
Press CLR key to clear display.
2-57
