TM 11-7025-221-10
2-33. Continue Configuration Routine - Continued.
Continue Configuration Routine - Continued
Operator action/message display
Step
~
5
Select and press one (0 - 4) key and then press ENTR key.
NOTE
Local mux or Rmux that was being configured when routine was interrupted
is selected.
6
Check your message display and press STEP key until you reach step in routine where interruption
occurred. At this point, continue procedures as directed in routine.
2-34. Download Standby Routine.
Perform the following procedures to download the configuration data in the local NVM to the NVM in
the standby TD-1337(V)/G.
NOTES
q Standby TD-1337(V)/G must be operating in inactive mode.
q When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
q Start with step 1 and perform the action in the procedures a s
directed. Messages that appear on the display are shown in bold
type.
Download Standby Routine
Operator action/message display
Step
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed, Then press SYSTEM
CONF key.
2
CONFIGURATION SELECTION
DISPLAY=1 GENERATE=2 TRANSMIT=3
Press "3" key and then press ENTR key.
2-100
