TM 11-7025-221-10
2-31. Generate Rmux Configuration for Downloading Routine (V3/V4 Models) -
Continued.
Rmux Configuration for Downloading Routine (V3/V4 Models) - Continued
Operator action/message display
Step
21
Numbers selected in steps 4
MEMORY * LOAD COMPLETE
MUX * DATA
COMPOSITE RATE= A KBS
22
Routine is complete. Press CLR key to clear display.
2-32. Edit Existing Configuration Routine.
Use this procedure to edit (change) existing configuration data in memory 1 or memory 2. This edit routine
allows you to advance through the configuration steps and change selected configuration data as required.
NOTES
q When a local mux configuration is edited, all demux configuration
data in NVM for the selected memory (1 or 2) is erased. Each
active demux will have to be reconfigured after local mux con-
figuration change is completed.
q When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
q Start with step 1 and perform the action in the procedures as
directed. Messages that appear on the display are shown in bold
type.
Edit Existing Configuration Routine
Operator action/message display
Step
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press SYSTEM
CONF key.
2
Press "2" key and then press ENTR key.
2-96
