TM 11-7025-221-10
2-31. Generate Rmux Configuration for Downloading Routine (V3/V4 Models) -
Continued.
Rmux Configuration for Downloading Data Requirements (V3/V4 Models) - Continued
Message heading/
Step
Definitions
No.
data required
Enter"1" to patch local mux or "2" to patch
18
CESE TLM PATCH OPTION
demux 1 to conditioned diphase modem (group
modem).
Entry:
_
NOTE
This step is not used if '12" or "3" was entered
in step 14.
Enter CESE telemetry equipment identification
19
CESE TELEMETRY EQUIP ID
number assigned to TD-1337(V)/G.
Entry: --
b. Procedures. Perform the following procedures to enter Rmux configuration for downloading data
in memory 1 or memory 2.
NOTES
q This q symbol in a step indicates that operator will enter con-
figuration data supplied by authority that originated the config-
uration.
q When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
q Start with step 1 and perform the action in the procedures as
directed. Messages that appear on the display are shown in bold
type.
Rmux Configuration for Downloading Routine (V3/V4 Models)
Step
Operator action/message display
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press SYSTEM
CONF key.
I
2
CONFIGURATION SELECTION
DISPLAY= 1 GENERATE=2 TRANSMlT=3
Press "2" key and then press ENTR key.
2-91
