TM 11-7025-221-10
2-31. Generate Rmux Configuration for Downloading Routine (V3/V4 Models) -
Continued.
Rmux Configuration for Downloading Data Requirements (V3/V4 Models) - Continued
Message heading/
Step
Definitions
No.
data required
Following entries are made for each active
13
PORT OUTPUTS, DEMUX/PORT
port output.
(a)
a. Demux number ("1", "2", "3", or
/Port
Port
1,
Demux _
"4") of demux supplying data to that
/Port
Port
2,
Demux _
port output.
/ Port
Port
3,
Demux _
/ Port
Port
4,
Demux _
b. Port number ("1" thru "8") of group
/ Port
Port
5,
Demux _
data that will be extracted from SG
/ Port
Port
6,
Demux _
applied to selected demux (a above) and
/ Port
Port
7,
Demux _
routed to that port output. (This is port number
/Port
Port
8,
Demux _
of Rmux port supplying selected group data in
SG.)
Enter "1" for CNCE or external standard,
TIMING SOURCE SELECTION
14
"2" for slave, or "3" for master.
Entry:
At each port, enter "1" if port is designated
15
EXTERNAL TIMING SOURCES
as an external timing source. Enter "0" for
each port not designated as a timing source.
Port 5 --
Port
1--
Port 6 --
Port
2--
NOTE
Port
3--
Port 7 --
port 8 --
Port
4--
This step is used if CNCE or external standard
was previously selected as the timing source ("1"
entered in step 14).
Enter number of demux ("1", "2", "3", or
16
SLAVE TIMING SOURCE
"4") receiving SG containing timing.
Entry:
_
NOTE
This step is used if "2" was entered in step 14.
Enter number of l/4-mile cable reels (1 to 8
COND Dl GROUP MODEM CABLE
17
for data rates up to 576 kb/s or 1 to 4 for
data rates of 1024 and 1152 kb/s) used with group
Entry:
_
modem input. Enter "0" when none are used.
NOTE
This step is used if "2" was entered in step 9
for port 1, 3, or 5.
2-90
