TM 11-7025-221-10
2-28. Generate Local Mux Configuration Routine (V3/V4 Models) - Continued.
Local Mux Configuration Data Requirements (V3/V4 Models) - Continued
Message heading/
Step
Definitions
No.
data required
Enter "0" if option is not used or "1" if
16KBS ORDERWIRE OPTION
8
option is used.
Entry:
Enter "0" if option is not used, "1" if
16/32 KBS USER OPTION
9
option is used and rate is 16 kb/s, or "2"
if option is used and rate is 32 kb/s.
Entry:
_
Enter number of demux ("1", "2", "3", or
10
16/32 KBS USER DEMUX
"4") receiving SG containing data for
dedicated user.
Entry: --
NOTES
q Step not used if "0" entered in step 9.
q Step not used in V4 model. (<'1" is automatically
entered if "1" or "2" was entered in step 9.)
11
Following entries are made for each active
PORT OUTPUTS, DEMUX/PORT
port output.
(a)
(b)
Port
1,
Demux
_
a. Demux number ("1", "2", "3", or
/Port
Port
2,
Demux
_.
/Port
"4") of demux supplying data to that
Port
3,
Demux
_
/Port
port output.
/ Port --
Port
4,
Demux
_
/ Port --
Port
5,
Demux
_
b. Port number ("1" thru "8") of group
Port
6,
Demux
_
/Port--
data that will be extracted from SG
Port
7,
Demux
_
/Port_
applied to selected demux (a above) and
routed to your port output. (This is port number
/Port_
Port
8,
Demux
_
of Rmux port supplying selected group data in
SG.)
NOTE
Ports 5 thru 8 not used in V4 model.
12
TIMING SOURCE SELECTION
Enter "1" for CNCE or external standard,
"2" for slave, or "3" for master,
Entry: __
2-69
