TM 11-7025-221-10
2-28. Generate Local Mux Configuration Routine (V3/V4 Models) - Continued.
Local Mux Configuration Routine (V3/V4 Models) - Continued
Step
Operator action/message display
NOTE
Go to step 11 if folIowing message is not displayed. (Message is not displayed
if "0" entered in step 9 or you are using a V4 model.)
10
key and then press ENTR key.
Press
q
11
At each port selected by prompt, perform substeps a and b below.
NOTE
Substep a below selects which demux (1 thru 4) is assigned to selected
port output. Substep b then selects which group data (Rmux port) will be
extracted from SG applied to selected demux and routed to your port output.)
key and then press ENTR key.
a. Press
q
key and then press ENTR key.
b. Press
q
12
TIMING SOURCE SELECTION
IF CNCE OR EXTERNAL STANDARD= 1
IF NOT, SLAVE=2 MASTER =3
key and then press ENTR key.
Press
q
NOTES
q If "1" key was pressed, go to step 13.
q If "2" key was pressed, go to step 14 (V3 model) or step 15 (V4 model).
q If "3" key was pressed, go to step 15.
2-73
