TM 11-7025-221-20
2-22. Display Card Replacement instructions - Continued.
Remarks
Action
Location/Item
Installation
Install and torque nut (18)
Assemble in sequence shown on
9. Replacement display
page 2-45.
to 25 to 30 inch-pounds and
card (28) and 2
and nut (23) to 16 to 18
sets of screws,
inch-pounds.
nuts, washers,
and terminal
lugs (18 thru
27)
Install
10. Capacitor bracket
(17)
11. 2 sets of nuts,
Install
Assemble in sequence shown on
page 2-45.
washers, and
terminal lugs
(9 thru 16)
A23A2P1 mates with J2 on display card.
Connect
12. Connector (8)
W1P1 mates with J1 on display card.
Connect
13. Connector (7)
Install and torque nut (9)
Align holes in display card with
14, 5 sets of screws
to 25 to 30 inch-pounds
standoffs on rear of front panel
and washers
and install, but do not tighten screws
(4 thru 6)
and nut (13) to 16 to 18
inch-pounds.
(4). Ensure that cable clamp (29) is in-
stalled.
Install and tighten.
Install
15. 3 sets of screws
and washers
(1 thru 3)
Tighten previously installed screws (4).
Tighten
16. 5 screws (4)
Install
17. Front panel
Install front panel in TD-1337(V)/G (para
2-21).
2-47
