TM 11-7025-221-10
2-30. Generate Rmux Configuration for Downloading Routine (V1/V2 Models) -
Continued.
Rmux Configuration for Downloading Data Requirements (V1/V2 Models) - Continued
Message heading/
Step
No.
data required
Definitions
19
COND Dl GROUP MODEM CABLE
Enter number of 1/4-mile cable reels (1 to 8
for data rates up to 576 kb/s or 1 to
Entry:
4 for data rates of 1024 or 1152 kb/s) used with
group modem input. Enter "0" when none are
used.
NOTE
This step is used if "2" was entered in step 9
for port 1, 3, or 5.
b. Procedures. Perform the following procedures to enter Rmux configuration for downloading data
in memory 1 or memory 2.
NOTES
This q symbol in a step indicates that operator will enter con-
figuration data supplied by authority that originated the config-
uration.
When a message is displayed that you do not understand, go
to paragraph 2-6. All messages that can be displayed on TD-
1337(V)/G are listed in alphabetical order. The operator action
associated with each display is described in the paragraph.
Start with step 1 and perform the action in the procedures as
directed, Messages that appear on the display are shown in bold
type.
Rmux Configuration for Downloading Routine (V1/V2 Models)
Step
Operator action/message display
1
Press FUNC key (one or two times) until SELECT FUNCTION is displayed. Then press SYSTEM
CONF key.
2
CONFIGURATION SELECTiON
DISPLAY=1 GENERATE=2 TRANSMIT=3
Press "2" key and then press ENTR key.
2-83
