TM 11-7025-221-10
2-30. Generate Rmux Configuration for D o w n l o a d i n g Routine (V1//V2 Models) -
Continued.
Rmux Configuration for Downloading Data Requirements (V1/V2 Models) - Continued
Message heading/
Step
Definitions
No.
data required
Enter number of demux ("1", "2", "3",
14
6/32 KBS USER DEMUX
or "4") receiving SG containing data for
dedicated user.
Entry:
_
NOTE
Step not used if "0" entered in step 13.
PORT OUTPUTS, DEMUX/PORT
Following entries are made for each active
15
port output.
(b)
(a)
a. Demux number ("1", "2", "3", or
Port 1, Demux
/ Port
/
Port
"4") of demux supplying data to that
Port 2, Demux
/
Port
port output.
Port 3, Demux
/
Port
Port 4, Demux
b. Port number ("1" thru "8") of group
/
Port
Port 5, Demux
/
Port
Port 6, Demux
data that will be extracted from SG
Port 7, Demux
/
Port
applied to selected demux (a above) and
/
Port
routed to your port output. (This is port number
Port 8, Demux
of Rmux port supplying selected group data in
SG.)
TIMING SOURCE SELECTION
Enter "1" for CNCE or external standard,
16
"2" for slave, or "3" for master.
Entry:
_
At each port, enter "1" if port is desig-
17
EXTERNAL TIMING SOURCES
nated as an external timing source. Enter
Port
5
--
"0" for each port not designated as a
Port
1--
timing source.
Port
2--
Port
6
_
Port
3_
Port
7
_
NOTE
Port
4--
Port
8
--
This step is used if CNCE or external standard "
was previously selected as the timing source ("1"
entered in step 16).
18
Enter number of demux ("1", "2", "3", or
SLAVE TIMING SOURCE
"4") receiving SG containing timing.
Entry:_
NOTE
This step is used if "2" was entered in step 16.
2-82
