TM 11-7025-221-20
2-16. TD-1337(V)/G Removal and Installation Instructions - Continued.
Remarks
Action
Location/item
Installation
I
Check identification plate (11) on re-
Check that proper model will be
8. TD-1337(V)/G
placement TD-1337(V)/G to ensure that
installed.
proper model (V1, V2, V3, or V4) is
being installed. If model designation is
missing or you suspect it is wrong, look
at rear connectors to confirm which mod-
el you have. (Rear connectors on each
model are shown on page 1-8.) Enter
correct model designation on plate if it
is missing.
Position slides (5) in rack slides and push
9. TD-1337(V)/G
in until locks (4) engage.
When locks on slides are bypassed, there are no mechanical restraints to
prevent TD-1337(V)/G from rolling out of slides and falling. If locks are
bypassed in steps 10 and 11, use a second person to help you support
TD-1337(V)/G to prevent possible injury to yourself and others.
NOTE
If cables-and connectors are not accessible for steps 10 and 11, release
locks and extend TD-1337(V)/G as necessary to reach and connect cables.
Remove spring pin (7), wingnut (8),
10. Ground cable for
Connect
lock washer (9), and flat washer (10)
El (6)
from E1. Install ground cable. Re-install
washers, wingnut, and spring pin.
Connect cables to rear of TD-1337(V)/G
Connect
11. System cables
as designated by system configuration.
Release locks (4). Use handles (3) and
Close
12. TD-1337(V)/G
push TD-1337(V)/G into rack.
Tighten
13. 8 fasteners (2)
Turn on
14. Rack power
Check that POWER AC and DC indicators
a. Set to ON.
15. POWER CB (1)
are lit.
b. If TD-1337(V)/G is being installed Correct configuration data will be in
NVM.
because red CESE assembly was
replaced, check that fault is
corrected.
TD-1337(V)/G will be configured for
If TD-1337(V)/G being installed
c.
is a replacement, perform op-
system operation when operational
test is performed.
erational test in para 2-17.
2-34