TM 11-7025-221-20
2-7. Checking Unpacked Equipment - Continued.
(4) One-at-a-time, pull each below listed card, perform the indicated check, and then reinstall card.
Card
Check
slot
Card part No.
Card
That red jumper plugs are installed in J1 through J6.
A2
XA2
SM-D-978560
That red jumper plugs are installed in J1 and J2.
A7
XA7
SM-D-978585
That red jumper plugs are installed in proper positions in J1
A9
XA9
SM-D-978555
through J7 for your model as shown on below illustration. If
necessary, rearrange red jumper plugs to proper positions<
That SM-D-978550 card is installed in V1 or V2.
A11
XA11
SM-D-978550/
That SM-D-978630 card is installed in V3 or V4.
SM-D-978630
That red jumper plugs are installed in J1 and J2.
A20
XA20
SM-D-978605
(5) Position top cover (2) on card file and tighten 20 fasteners (1).
d. Check to see whether the equipment has been modified.
2-8. installation instructions.
The TD-1337(V)/G is installed with quick-disconnect slides in a 19-inch equipment rack. Perform the "in-
stallation" portion of paragraph 2-16 to install a TD-1337(V)/G. After installation, perform the operational
test in paragraph 2-17.
2-10
