TM 11-7025-221-20
2-7. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,
report the damage on SF 364 (Report of Discrepancy).
b. Check the equipment against the packing slip to see if the equipment is complete. Report all dis-
crepancies with the instructions of TM 36-750.
c. Perform (1) through (5) below to check that correct complement of plug-in cards are installed and
that red jumper plugs are installed on certain plug-in cards. Report all discrepancies with the instructions
of TM 36-750. Correct any discrepancies.
(1) Use cross tip No. 2 screwdriver and loosen 20 fasteners (1) and remove top cover (2).
(2) Check that identification plate (3) has proper model designation (V1, V2, V3, or V4) listed. If model
designation is missing or you suspect it is wrong, look at rear connectors to confirm which model
you have. (Rear connectors on each model are shown on page 1-6.) Enter correct model designation
on plate if it is missing.
(3) Use following list and check that correct complement of plug-in cards are installed for your model.
There should be a plug-in card installed in cacti card slot that has an "X' listed under your model
number.
2-9.
