TM 11-5805-694-23P/TO 31W2-4-287-14
SECTION I
INTRODUCTION
Code
Definition
1.
Scope
PA -
Item procured and stocked for anticipated or
This manual lists spares and repair parts; special tools;
known usage.
special test, measurement, and diagnostic equipment
XA -
Item is not procured or stocked because the
(TMDE), and other special support equipment required
requirements for the item will result in the
for performance of organizational and direct support
replacement of the next higher assembly.
maintenance of the AN/FCC-97 through AN/FCC-
97(V)4. It authorizes the requisitioning and issue of
spares and repair parts as indicated by the source and
NOTE
maintenance codes.
Cannibalization or salvage may be
used as a source of supply for any
2.
General
items source coded above except
This Repair Parts and Special Tools List is divided into
those coded XA and aircraft support
the following sections:
items as restricted by AR 700-42.
a. Section II. Repair Parts List. A list of
spares and repair parts authorized for use in the
(2) Maintenance code.
Maintenance
performance of maintenance. The list also includes
codes are assigned to indicate the levels of
parts which must be removed for replacement of the
maintenance authorized to USE and REPAIR support
authorized parts. Parts lists are composed of functional
items. The maintenance codes are entered in the third
groups in numeric sequence, with the parts in each
and fourth positions of the Uniform SMR Code format as
group listed in figure and item number sequence.
follows:
b. Section III.
Special Tools List.
Not
(a) The maintenance code entered in
applicable.
the third position will indicate the lowest maintenance
level authorized to remove, replace, and use the support
Part Number Index. A list, in National item identification
item. The maintenance code entered in the third
number (NIIN) sequence, of all National stock numbers
position will indicate one of the following levels of
(NSN) appearing in the listings, followed by a list, in
maintenance:
alphanumeric sequence, of all part numbers appearing
in the listings.
National stock numbers and part
Code
Definition
numbers are cross-referenced to each illustration figure
O-
Support item is removed, replaced, used at the
and item number appearance.
organizational level.
F
-
Support item is removed, replaced, used at the
3.
Explanation of Columns
direct support level.
a. Illustration. This column is divided as
follows:
(b) The maintenance code entered in
(1) Figure number. Indicates the figure
the fourth position indicates whether the item is to be
number of the illustration on which the item is shown.
repaired and identifies the lowest maintenance level
(2) Item number. The number used to
with the capability to perform complete repair (i.e., all
identify item called out in the illustration.
authorized maintenance functions). This position will
b. Source, Maintenance, and Recoverability
contain one of the following maintenance codes:
(SMR) Codes.
(1) Source code. Source codes indicate
Code
Definition
the manner of acquiring support items for maintenance,
D
-
The lowest maintenance level capable of
repair, or overhaul of end items. Source codes are
complete repair of the support item is the
entered in the first and second positions of the Uniform
depot level.
SMR Code format as follows:
Z
-
Nonreparable. No repair is authorized.
(3) Recoverability code. Recoverability
codes are assigned to support items to indicate the
disposition action on unserviceable items.
The
recoverability code is entered in the fifth position of the
Uniform SMR Code format as follows:
1
